Good morning everyone, today we are going to see a very beautiful craft with a very realistic result: we are going to see how to make flowers with crepe paper.
Makings:
- Crepe paper strips:
- 10 cm x 20 cm.
- 6 cm x 30 cm.
- 8 cm x 30 cm.
- Scissors.
- Ruler.
- Glue gun.
Processing:
- Cut the strips of crepe paper with the measures indicated above.
- Measure about an inch from the edge of the XNUMX-inch paper, fold this measure over itself and roll up.
- Make a straight cut about two centimeters more or less, without reaching the other end of the paper, turn the scissors and continue with a rounded shape until you reach the end. As indicated in the picture.
- Unwind and a jagged shape will come out as seen in the photograph.
- Do the same with the three-inch strip. We go back to doing what we did with the six centimeter, but this time do the cut to a centimeter and a half approximately. Unroll.
- Fold in four parts the ten by twenty centimeter strip and cut a rounded shape from the bottom.
- Start to roll the six-centimeter strip on itself, pasting from time to time so that the curler remains attached.
- Do the whole strip to the end.
- Ves opening the petals by the ends rounding the edges out.
- Glue the other three-inch strip where the previous one ends and do the same.
- Open the petals equally. Widened the edges of the petals.
- Now glue the four petals that remain on the stem and go placing as you see that they are missing.
- Shape them by rounding out.
- Cut out rectangles of approximately three by eleven centimeters. Fold in half and cut out a leaf shape.
- Glue one or two leaves to the stem. This will end up giving the flower a realistic shape.
Make a few and you will have a beautiful bouquet. I hope you like it and it inspires you, See you at the next.